Glidden^® Redwood Stain

Area Preparation: 

Surfaces to be coated must be clean and dry. Remove all dust, dirt, mildew, oil, loose wood fibers and other contaminants. Previous coatings must be completely removed. To ensure proper penetration, weathered, dirty or mildewed surfaces should be cleaned with a wood cleaner prior to applying stain. After rinsing, ensure surface is free of standing water. WARNING! If you scrape, sand, or remove old paint, you may release lead dust or fumes. LEAD IS TOXIC. EXPOSURE TO LEAD DUST OR FUMES CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a properly fitted NOISH-approved respirator and prevent skin contact to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the USEPA National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. Follow these instructions to control exposure to other hazardous substances that may be released during surface preparation.

Application: 

CAUTION: SURFACES ARE SLIPPERY WHEN WET. USE CAUTION WHEN WALKING ON WET SURFACES DURING APPLICATION. Do not thin. Intermix containers to ensure color uniformity. Stir thoroughly and often during use. Apply to a small area and allow stain to dry to ensure acceptable appearance and penetration. Apply two thin coats with a high quality brush, paint/stain pad or with spray equipment. Allow first coat to dry thoroughly before applying the next coat. When applying by roller or spray, always back-brush for best results. To help avoid lap marks, apply to only a few boards at a time, and maintain a wet edge.

Application Temperature: 

Apply when no precipitation is expected for 24 hours, and when air and surface temperatures are 50°F (10°C) to 90°F (32°C) and will remain at 50°F (10°C) or above for the next for 48 hours. Avoid staining in direct sunlight or hot surfaces.

Drying Time:

Dry time at 50°F to 85°F. To Touch: 1 hour   Recoat: 3-4 hours. Application in high humidity or in temperatures below 50°F may prolong drying times. Allow 24 to 48 hours of drying time before light foot traffic or replacing furniture.

Coverage:

Approximately 250-300 sq. ft. (23.2-32.5 sq. meters) per U.S. gallon (3.78 Liters) depending on application, wood texture and porosity.

Cleanup: 

Cleanup tools with warm, soapy water.

Recommended Substrates:

Exterior wood

Warning: 

Please refer to the Product Label, Technical Data Sheet (TDS) or Safety Data Sheet (SDS) for safety and detailed application instructions.